Description:
By popular demand the TK Custom Moon Clip Saver Tool is back in stock! This tool can straighten bent full moon clips.
Moon Clip Saver Tool
S & W 6, 7 & 8 - Shot (User Instructions)
A Hard-flat surface is recommended to push against.
- Place the bent moon clip onto the beveled depression/machined circle in the base.
- Place the center press pin starting angle “B” facing out, into the top.
- Insert top assembly into the base holding the bent moon clip.
- Give several forceful presses down onto the moon clip, flip the moon clip over and repeat.
- Do this until one side of the moon clip (is cupped at this point) has all the outside edges resting evenly on a flat surface.
- Reverse the center press pin so finishing angle “A” is facing out, and reinsert into the top.
- Place the moon clip with the cupped side down into the beveled depression/machined circle of the base.
- Insert the top assembly into the base.
- Press down on the moon clip pistol repair tool and gradually lighten the pressure until the moon clip is straight.
- A Hard-flat surface is recommended to push against.
- Check for straightness/flatness on the flat bottom of the base.
- Repeat the steps if necessary, until moon clip is straight and flat.
