Our favorite picks for the season


CYLINDER CHAMBER HONING

Polishing the revolver chambers makes the cases easy to extract, and makes the chambers easy to clean. When a revolver comes from the factory, the chambers in the
cylinder are often just rough-cut and can contain burrs and cutting marks. These burrs and cutting marks can make it difficult to extract empty cases, and difficult to remove powder fouling. Make them easy to clean with our cylinder honing service.

Price : $85 + Return Shipping

NOTE

Our work on cylinders rechambered to 9mm are LIMITED to our customer's using standard 9mm ammo or low pressure reloads, which are 34,000 - 35,000 psi chamber pressure or less. Same chamber pressures apply to firing of .38 SPL & .357 Mag. Examples of FACTORY Brands are: Winchester, Federal & Remington.

Absolutely NO 9mm Nato, 9mm +P or 9mm +P+, all which are far beyond the 34,000 - 35,000 psi chamber pressure our Ruger .45 ACP & 9mm cylinder machining is intended for. Usually 38,500 psi, which WILL Stick!

If you try to use these high pressure ammo, you will experience cases sticking in all chambers.

We cannot warranty our work, if you disregard our warning/notice on high pressure ammo.

When rechambered to 9mm the cylinder will still shoot NON-HIGH Pressure ammo, 38 SPL or 357 Mag with or without the proper Moon Clip.

Reloaded range brass, with the unsupported barrel chamber bulge, will not resize properly and results in inferior ammo for use in this conversion!

Fill out the (Work Order) and ship us the revolver cylinder assembly, payment info or have us call you when the work is done.

CONTACT US / SHIP ITEMS TO:

TKC
503 N CHURCH ST / PO BOX 333
THOMASBORO, IL 61878-0333

9 AM - 12 Noon
MONDAY - FRIDAY
CENTRAL STANDARD TIME